Beaver Spectrum LED Strobe Light 60m Waterproof Dive Torch  £42.95

Beaver Spectrum LED Strobe Light - Orange

The iconic Beaver Spectrum Strobe Light updated and improved, used extensively in SCUBA Diving and a large variety of other sports where a reliable and powerful LED Flashing Strobe Light is required. Compact flashing LED strobe light.

Requires 3 x AA Batteries, rechargeable versions may also be used if desired.

Supplied with a fully adjustable heavy duty Velcro strap to enable positioning in a convenient location, such as attached to the shoulder area of a Divers BCD.

The Spectrum LED Strobe Light is designed as a personal strobe light for for underwater use to maintain contact in dark or limited light conditions to both be seen and maintain contact between groups.

Features:

•  On/Off Switch: Rotary Type with Reed Switch.
• Waterproof to 60 metres / 196.8 ft / 65.6 yd
• Uses 3 x ‘AA’ size 1.5 Volt Alkaline Batteries
• Burn Time = 72 Hours +
• Intensity = 0.75 Candela - 430 cd/M2
• Flash Rate = 1 - 1.5 Flashes Per Second
• Visibilty = Approximately 3 Kms / 1.86mi
• Brightness: 130 lumens
• Velcro Type Attachment Strap
• RoHS Compliant - CE Standard 2011/65/EU
• Colour: Orange
• Dimensions:
  • Diameter: 34mm  /  1.33in
  • Length: 127mm  /  5in
• Weigh (without batteries): 103gr  /  3.63oz

Installing or replacing Batteries:

1. To install new batteries, install three new or freshly charged ‘AA’sized batteries, by carefully unscrewing the Strobe section from the main body of the unit and removing the battery holder. Insert the batteries into the holder, ensuring correct polarity. Place the battery holder back in to the main unit, ensuring that it is aligned correctly. Check the O-rings are in good condition and lubricated with silicone grease and fully screw the Strobe section back onto the body ensuring the threads are correctly aligned.

2. To change the batteries carefully unscrew the Strobe section from the main body of the unit. Remove the battery holder from the main body. Carefully remove old batteries and dispose of responsibly if relevant. Insert new or re-charged ‘AA’ size batteries into the holder ensuring correct polarity Place the battery holder back in to the main unit, ensuring that it is aligned correctly. Check the O-rings are in good condition and lubricated with silicone grease and fully screw the Strobe section back onto the body ensuring the threads are correctly aligned.