Palm Equipment Unisex Shuck Full-cut Canoe Helmet  £99.00

Palm Equipment Shuck Full-cut Helmet - Unisex

Like a pea in a pod – wearing the Shuck helmet feels natural‚ fitted and secure. With a tough ABS shell and multi-impact EPP liner‚ the Shuck protects you from the kinds of hits kayaking‚ rafting and other watersports can serve up. Dial in your fit with the occipital stabiliser keeping the helmet secure and seated in place. The quick drying fabric liner cups your head‚ Polygiene treated to keep it fresh (it's washable too).

This helmet is designed to protect impact caused by collision of head with anobstacle while canoeing and white water sports. It has passed EN 1385:2012 to show conformity to the EHSR of Regulation(EU) 2016/425 and regulation(EU) 2016/425 as brought into UK law and amended.

FOR WATERSPORTS USE ONLY. NOT FOR ROCK CLIMBING, CYCLING OR MOTOR VEHICLE USE

Features:

• Materials
  • ABS injection moulded plastic shell with multi-impact protection
  • Expanded polypropylene (EPP) multi-impact foam liner
• Adjustment
  • Dial adjustable occipital stabiliser
  • Adjustable straps with side release buckle
• Washable frabric liner with Polygiene odour control treated
• Chin strap protector
• ABS ear covers with 5 mm comfort foam lining
• Quick drying comfort liner
• Self adhesive fit pad kit 
• Weight (M): 581 g  /  20.49 oz

Watch this short video to find out more about the Palm Shuck Full-cut Helmet:

Technical Features:

• Product Code: 12130
• Materials: ABS injection moulded plastic shell, EPP multi-impact foam liner
• Fabric Composition: 100% polyester
• Certification: Approved to CE watersport safety standard EN1385

CE approved: Our safety hardware and helmets belong to the CE group of PPE (personal protective equipment) and are certified to the required European Conformity directives. 

Polygiene: Wear more, wash less. A permanent fabric treatment which inhibits the bacteria responsible for that unpleasant damp gear smell. Polygiene’s Bluesign approved treatment is manufactured in the EU using low concentrations of silver salt recovered from recycled electronics.

Sizing Guide:

Circumference: Measure around the largest area of your head, above the eyebrows and ears.

Fitting:

1. Try on your helmet – it should cover your forehead with the peak just above your eyes – it should be a close fit, but not uncomfortably tight.
2. The helmet should not be able to move around on your head or be pulled back to expose your forehead.
3. To prevent the helmet from rotating forward over your eyes you can twist the rear dial clockwise to tighten the fit.
4. To change the helmet’s front/back balance slide the straps through the three-way adjuster – take time to tension the chin straps equally.
5. Pull the chin strap through the quick release buckle to tighten under your chin – the fi t should be snug, but not uncomfortably tight.
6. To refine the fit, use the self adhesive fit pads. Remove the fabric liner to expose the EPP foam.
7. Add fit pads where you need them – check for fit and reposition if necessary for a snug fit with no pressure points before sticking them down.
8. Replace the liner and try on your helmet – if the fit is still not satisfactory, repeat the steps.