Scubapro Superflow Low Pressure Regulator & BCD Hoses Replacement From £30.00

Scubapro Superflow Low Pressure Hoses for BCD & Regulators

A replacement genuine Scubapro Low Pressure Superflow regulator hose. Scubapro BCD Hoses are the are the same as their Regulator Hoses other than length. If replacement is required you can retain the coupling for further use. 

Scubapro Superflow LP (Low Pressure) Regulator and BCD Hoses are made from high quality materials so they last longer and are designed to allow the maximum flow and therefore best breathing performance for Scubapro Regulators. These hoses come with a reulator fitting as standard but can take a Scubapro QD BPI Connector to make into an inflator hose.

These hoses are a traditional rubberised hose not a braided "miflex" style hose. The hoses are the standard Scubapro lengths, 3/8ths male end for your First Stage with a standard regulator swivel fitting on the other end, ready to easily fit to any Scubapro Regulator.

The Scubapro superflow hoses allow for a Scubapro Quick Disconnect (QD) fitting to be added to any length hose to allow connection to the Scubapro BPI Inflator and Scubapro Drysuits. The fititng is suitable for most seatec fittings but if in doubt check with one of our technicians before ordering.

Features:

• 3/8" male thread will fit most regulator 1st stages today (except some Mares and older Apeks that use a 1/2" thread and the female end is the universal 9/16” that fit all second stages without a swivel or special connection.
• The female end is fitted with a high torque nut that requires a special tool to tighten properly.
• Neoprene rubber is used for the outer coating allow Scubapro Superflow hoses to remain flexible at all temperatures
• Reinforcing fibre mid layer holds pressure increases the life of the hose 
• The inner bore is completely smooth and matches the internal bore of the regulator first stage for an unobstructed air flow
• Rubber component are impregnated with a vanilla essence to get rid of the rubber odour

Scubapro Hose Lengths & Suggested Uses:

• 56cm - Standard BCD inflator hose length
• 64cm - Standard BCD inflator hose length
• 75cm - Standard regulator hose length
• 80cm - Standard regulator hose length - A longer than normal primary hose for a bit more movement or slack if you run it from a left post on a twin set maybe.
• 90cm - Standard drysuit inflator hose length, some prefer a 1m hose for drysuit inflation
• 1m - Standard Octopus Hose Length (Black and Yellow) (Sometimes a preffered drysuit inflator hose length)
• 1.2m - Long Octopus Hose
• 2m - Technical Divers standard length primary regulator hose
• 3m - Extra long hose