|Home PageRegulatorsScubapro Universal 200 / 300 Bar DIN Conversion Kit For Regulators||
Scubapro Universal 200 / 300 Bar DIN Conversion Kit For Regulators £42.50
Scubapro DIN 200 / 300 Bar Conversion Kit Universal
300 Bar DIN Kit for Scubapro regulators to also fit 200 Bar Cylinder valves.
Fits all Scubapro Regulators.
Note that should the small O Ring be used on the MK2 you will seal off gas supply to the HP Gauge. Best fitted by competent persons.
There are 3 reviews with an average rating of 4.66
Sabrina from United KingdomOwner10 September 2011 13:31
I bought two of these to convert two of my ScubaPro first stages to din. The conversion is simple once you have removed the old A-Clamp. You have to be careful however as there are two got-yas. The first got-ya is that you have to remove the outer section to be able to screw the clamp in properly and safely. The second got-ya is you have to tighten it up to a certain torque setting otherwise you can split the case. I would recommend letting a ScubaPro proffesional to install it but the product works well.
Anonymous from United KingdomOwner14 July 2020 12:47
Perfect for the job, fitted to my MK25 in 5 minutes by my local dive shop tech in exchange for a packet of biscuits!
Have used it in anger now, no leaks, very pleased.
Great service from Jackson too
Anonymous from United Kingdom22 February 2022 15:42
Thanks for a prompt service at a reasonable price too. Note about o-rings was really useful too! Definitely recommend and would use again - thanks :-)
Gary from United Kingdom asks
hi I would like my Mk25 A clamp first stage converted to DIN 232bar (not 300 as my tanks are 232)is this product suitable? Kind regards Gary Aiken
> Loyalty Reward Scheme <